Happymodel Snapper7 Frsky version with 3 units 450mah 1S 3.8v HV 80C

by HappyModel
Save 34%
$128.80
$84.99

Happymodel Snapper7  Racing drone Frsky vrsion with 3 units 450mah 1S 3.8v HV 80C

Motor:
Mode: SE0703 KV19000
Configu-ration:9N12P
Stator Diamter:7mm
Stator Length:3mm
Shaft Diameter:Φ1.0
Motor Dimension(Dia.*Len):Φ10*14.5
Weight(g):2.5
No.of Cells(Lipo):1S

Flight controller
Firmware: Betaflight_3.3.0_Crazybee
MCU: STM32F303CCT6 (72MHZ, 256K FLASH)
Sensor: MPU-6000(SPI connection)
Board size: 28.5 * 28.5MM
Board weight: 3.5 g
Power supply: 1S battery input (DC 3.5-4.35V)
Built-in 5A(each) Blheli_S 4in1 ESC Dshot600 ready
Built-in Frsky receiver with telemetry(D8/D16 switchable)
Built-in Betaflight OSD(SPI Control)
Built-in Current meter (Max 14A,could be modified to 28A by replace resistor)
Built-in 5V 0.8A BEC with LC filter
Built-in voltage detection
BLHELI_S pass-through Ready
Heading LED Ready

Onboard 4in1 ESC
Power supply: 1S LiPo/LiPo HV (4.2v/4.35v)
Current: 5A continuous peak 6A (3 seconds)
Support BLHeliSuite programmable
Factory firmware: O_L_5_REV16_6.HEX
Default protocol: DSHOT600

AIO Camera&VTX
Output power: 25mw
Frequency: 48CH
Input voltage: 3.3V 5.5V
Current consumption: 300mA(type)
Camera resolution: 700TVL
Field of view: 120°
Video Format: NTSC
Antenna: RG178 antenna
Frequency: 5.8GHz 6 bands 48 channels
With Raceband: 5474 5945 MHZ
Size: 13.9"12.0mm ( L*W )
Weight: 3g

Lipo Battery
Capacity:450mAh
Voltage:3.8v
Continuous Discharge Rate: 30C
Instantaneous discharge rate: 60C
Size: 60mmx18mmx7mm
Weight: 13.6g
Connector: PH2.0 

Package includes:
Snapper 7 Frame*1
Crazybee F3 FC (Frsky and Flysky option)*1
SE0703 KV19000 Motor*4
40mm 3-blades propeller(4cw+4ccw)*1
AIO Camera & VTX*1
3.8v 450mah 30C/60C battery*3
USB Lipo/LIHV Charger*1
Propeller disassemble tool*1
Screwdriver*1

You recently viewed

Clear recently viewed

QUESTIONS & ANSWERS

Have a Question?

Be the first to ask a question about this.

Ask a Question
Become a member and save $3 storewide! Register or Login.