F4 WHOOP PRO Flight Control

by Makerfire
Sold out
$35.90

Please NOTE, this is for pre-order only and we are not sure when will be in stock, if you have placed the order and DO NOT want to wait till it's restock, feel free to contact us for cacelling, thank you. 

F4 WHOOP PRO flight control is suitable for 1S (3.7V-4.2V lipo battery) brushless system control, internal use STM32F411 as main control with MPU6000 gesture sensor integrated video overlay OSD image display, the key highlights integrated four 5A brushless Adjust driver and FRSKY receiver in one.

Specifications: 
Firmware: betaflight_3.3.0_MATEKF411RX
Betaflight target: MATEKF411RX
MCU: STM32F411CEU6
Sensor: MPU-6000(SPI connection)
Power supply: 1S battery input (DC 3.5-4.35V)
Built-in 5A(each) Blheli_S 4in1 ESC Dshot600 ready
Built-in Frsky receiver with telemetry D8
Built-in Betaflight OSD(SPI Controll)
Built-in 5V 0.8A BEC with LC filter
Built-in voltage detection
BLHELI_S pass-through Ready

Board size: 28 * 28MM
Board weight: 2.8 g

ESC parameters:
Power supply: 1S LiPo/LiPo HV (4.2v/4.35v)
Current: 5A continuous peak 6A (3 seconds)
Support BLHeliSuite programmable
Factory firmware: O_L_5_REV16_7.HEX
Motor connector: JST PH1.25 3pin
Signal Support: Dshot150/Dshot300/Dshot600/Oneshot125/Multishot/PWM

Receiver parameters:
SPI BUS receiver
Compatible Frsky D8/D16
Channels: 8ch/16CH
Failsafe support
No ground interference ( Transmitting and receiving 1 m from the ground): 300m






You recently viewed

Clear recently viewed

QUESTIONS & ANSWERS

Have a Question?

Be the first to ask a question about this.

Ask a Question